Requirements

• Use Max 6.1+ in 32bit mode - Expect strange behavior on earlier versions!

Software Installation

• Download the ZIP file, unpack on a safe place on your main hard drive

• Put the HistWhist folder in Max File Preference and include subfolders

• Setup DSP AUDIO STATUS in Max (see screenshot)

  • Set up the sound card

  • Set sampling rate to 96000, IO Vector size to 2048, Signal Vector Size to (minimum) 512

  • Overdrive ON, Parallel Processing ON

• Quit Max (so that preferences are stored). Relaunch Max

Software Setup

• Launch two patches in the same Max instance: DSP1 and DSP2 patches

  • DSP1 patch si the main patch

  • DSP2 patch is the SuperVP Soundfile Player patch (separate to enable parallel processing

• Patch Initialization

  1. Loadbang: Press the bang and then the Loadbang button once in the Match Patch (screenshot 2)

  2. Choose “System Un” twice

  3. Turn DAC ON

  4. Choose RESET in the Antescofo Window‘s Score Menu

  5. Activate BCF from Main window (choose BCF from Menu and Toggle)
  
  6. Choose the movement to play

ADC

Only mono input is required : the sound coming from the violin microphone.

Loudspeaker Setup

This piece uses 4 loudspeakers in a vertical column, and in the middle of the stage.

The Loudspeaker setup and their mapping to Max (through console and soundcard) should follow these configurations:

• DAC 1 -> Top Speaker Facing the Public

• DAC 2 -> 2nd speaker from top, facing RIGHT (from public or at 3 o’clock)

• DAC 3 -> 3rd speaker from top, facing backwards

• DAC 4 -> 4th speaker from top, facing LEFT (from public or at 9 o’clock)

The four speakers can be mounted on a subwoofer facing the public. Subwoofer routing is to be taken care of on the mixing console. See pictures below:

Setting up the MIDI Interface

During performance, automatic actions (triggered by the computer musician) will open and close specific effects. Levels for each effect can be controlled during live performance using a BCF2000 MIDI Interface (or similar). The BCF2000 interface should be setup to send and receive controls. BCF2000 controls will be then visualized on the Relative Fader window of the Max Patch.

The MIDI Hardware faders should be configured (and tagged) to reflect the following mapping of parameters:

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

    </tr>

</tbody>

Performance Notes

The computer music performer action during a performance is as follows: Triggering of Actions with the violinist according to the annotated score (in the HistWhist-PDF-Scores folder). Triggering of actions can be done using the _Upper Arrow Key _on the keyboard. On top of this, the computer music performer is responsible for live mixing of effects and sounds on the BCF2000 MIDI Interface (or similar). The PDF scores contain minimal description of active effects on each action that should be controlled on the MIDI Interface.

For example: The score excerpt above (from the beginning of movement 4) indicates triggering an event on the first Eb5 from violin. Th event name is e2001 (that will be visualized in the AntescofoWindow. Additionally, it indicates to the computer music performer that buf1 (Buffer 1) is active, and Harms (harmonizers) are automatically moving. This means that for live mixing, the computer music performer can focus on associated Faders. Additionally, after e2004, the performer is instructed that the Violin input is cut out automatically.